cannot access slave HD files

From: keith bayer (k.bayer_at_insightbb.com)
Date: 05/11/03 

Date: Sat, 10 May 2003 23:32:48 -0700

i did a full install on my new 60GB hard drive of XP. I
set the jumpers on the old 20GB HD to slave. Everything
boots ok- here is my problem. When I try to access the 2
drives everything works OK on drive F: (the 60GB) but
when I try to access my personal files on drive C: I get
an error message- cannot access C:\documents and
settings\keith bayer is not accessable Access is denied.
Please advise. Thank you.

Relevant Pages

  • Re: Help installing Fedora
    ... Each IDE/ATA channel can support either one or two devices. ... giving each device a designation as either master or slave, ... the reasons why drives don't always "play nicely together" has to do ...
    (comp.os.linux.setup)
  • Re: G4 400Mhz wont boot Tiger
    ... > jumpers, removed one harddrive, and now it boots fine. ... > isn't as tolerant of misjumpered drives as Panther was. ... > have both harddrives connected. ...
    (comp.sys.mac.system)
  • Re: G4 400Mhz wont boot Tiger
    ... >> jumpers, removed one harddrive, and now it boots fine. ... >> isn't as tolerant of misjumpered drives as Panther was. ... >> have both harddrives connected. ...
    (comp.sys.mac.system)
  • Re: Upper Lower Filters in XP Registry
    ... I'd just switch the middle and end connectors (moving the drives ... currently have jumpered as Slave should be that way - some drives cannot ... support being a master. ... > the drive to the slave CD and the top connector to the master DVD. ...
    (microsoft.public.win2000.registry)
  • Re: computer gone wild and I have no clue
    ... >>> These are both according to what it says on the drives. ... >>> (slave) I bring this up because I?ve lost at least three slave drives ... >> I brought this up because I'm unsure if my jumpers are correct and I ... >> From what I saw on the Master there are three separate jumper settings. ...
    (comp.sys.mac.system)