Security templates, problem with multiple settings

From: Peter Rus (peter_at_rus.cz)
Date: 07/26/05 

Date: Tue, 26 Jul 2005 13:50:11 +0200

Dear Colleagues,

in our security template we want to turn off netbios support on all network
interfaces.
It is usually done by setting
MACHINE\SYSTEM\CurrentControlSet\Services\NetBT\Parameters\Interfaces\Tcpip_
*\NetBiosOptions=2

But, do you know how to let correctly interpret that wildcard?
For sure it is possible to script it, but I would prefer some in-template
action, if possible.

thank you very much and best regards,

Peter

Relevant Pages

  • Re: How to save the Firewall Zone setup for wireless Interface setting
    ... Run YaST2 again, and setup the card to managed, start on boot, no usercontrol, ... no network manager, and save. ... # setting up a lot of interfaces. ... # Switch on/off debug messages for all network configuration stuff. ...
    (alt.os.linux.suse)
  • Re: load balancing with a failover
    ... The tunnel interfaces have addresses ... from other network though ... Enter configuration commands, one per line. ... 1w0d: RT: delete subnet route to 192.168.128.20/30 ...
    (comp.dcom.sys.cisco)
  • Re: Establish persistant outbound connection for covert application
    ... which firewalls are running etc.) and then communicate its ... the actual network layer. ... They do have 2 network interfaces in case I want to chain them between a PC ... They also have a wireless interface so I can hook into the machine if I am ...
    (Security-Basics)
  • Re: C++ in embedded systems
    ... OOD is useful: ... Network interfaces. ... I'm looking at a third GDI that will use OpenGL. ...
    (comp.os.linux.embedded)
  • RE: RAS and Routing question...
    ... of three network interfaces on SBS can allow incoming VPN connection. ... Firstly, this is SBS newsgroup, if your system is Windows Server 2003, ... Go to the client and establish the VPN connection to the SBS Server, ...
    (microsoft.public.windows.server.sbs)