Windows firewall udp traceroute blocking
There is a problem with Windows firewall. If you try to make traceroute from
unix box to windows box it fails because it uses UDP protocol (Windows use
ICMP protocol). Only solution so far is to disable Windows firewall. If I put
rule to allow any to any and protocol any for both inside and outside it
fails too.
Is there any solution for this problem because disabling Windows firewall is
not an option?
.
Relevant Pages
- Re: Which protocols & bindings?
... >> Windows Firewall on the machines? ... > because the Windows Firewall doesn't affect that protocol. ... >> have to have IPX/SPX on a couple of my machines. ...
(microsoft.public.windowsxp.setup_deployment) - RE: Windows XP firewall and RPC question
... suggest you contact the manufacturer and confirm the following things: ... I am providing you the steps to disable Windows Firewall via GPO: ... The policy is a computer-based policy. ...
(microsoft.public.windows.server.sbs) - Re: Error Message: 0x8024D007 as of 04/05/2009 - present
... We disable Windows Firewall as part of GP, and as I mentioned I do not install AV software until after all Microsoft Updates are complete. ... Did you try a manual installation attempt of the WUA from a Command Prompt to a non-connected system, after stopping BITS and AU, adding /wuforce, reboot, and then connect the system to see if it could ...
(microsoft.public.windowsupdate) - Re: Windows XP fire wall and Norton Systemworks 2004
... NSW does not include a firewall and it should not prompt you to disable Windows Firewall. ... Norton Internet Security does and you may safely ... Upon succesful of installation, a message appeared asking me to disable Windows Firewall in order for Systemworks to run to its fullest. ...
(microsoft.public.windowsxp.general) - Re: Windows Firewall
... shows that Group Policy settings are enabled for Windows Firewall. ... When I have attempted to disable windows firewall to test the ...
(microsoft.public.win2000.security) |
|
