ANY EXPERIENCE WITH WebRamp 700s?
From: Calvin Lane (clane_at_nubiandirections.org)
Date: 05/21/03
- Next message: Marcelo Birnbach [MS]: "Re: Howto: Run Application from Network Drive"
- Previous message: Michel Gallant \(MVP\): "Re: Howto: Run Application from Network Drive"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Date: Tue, 20 May 2003 22:00:11 GMT
I'm setting up a VPN connection into my network. I have dynamically
assigned IP address from my cable ISP service. I was able to secure a
domain name from one of the DNS services on the internet that allows you to
map a dynamically assigned IP to a fully-qualified domain name. Currently,
I'm unable to access the inside of my network from the outside through the
WebRamp 700s. I noticed that when I change to Standard mode, I can use LAN
IN and allow certain specific ports into my network. When I switch to
either NAT or NAT with DHCP, my LAN IN option goes away. I need the NAT
obviously to translate from the 192.168.x.x IP addresses to the legal ones
on the other side. How do I set up the WebRamp to allow certain
ports/protocols into my network, while at the same time NAT'ing my IPs to
legal routable ones? Thanks.
clane@nubiandirections.org
- Next message: Marcelo Birnbach [MS]: "Re: Howto: Run Application from Network Drive"
- Previous message: Michel Gallant \(MVP\): "Re: Howto: Run Application from Network Drive"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
