Re: Configuring a VPN client for a dlink dfl800 firewall


The dlink support pages has something on "How do I configure the
DS-601/DS-605 VPN software client to connect to the DFL-210/800/1600?"
which sounds to me very much like the thing you want to do. But if it
does not work you must give more details. What would be the benefit of
pointing you again to this article if you tried it before but don't
mention it nor mention what did go wrong?

Basic instructions are always in the manual and it is futile to repeat
all that here. Read the manual. Try it. It contains instructions how
to set up IPSec, PPTP, and L2TP. If you failed post what you have
tried exactly, what settings you have used, what exact error messages
you saw, messages in the logs etc.

Gerald

Hi,
thanks for your post. I need to check again all the settings (IPSec
connection): I have no time to do it during these days, as that's an
extra thing I have to fix and I'm kinda busy. Last Sunday I followed
some steps in the manual and set the firewall in a way similar to
what is written in the Dlink support site but I still had some trouble
with the IKE in the first phase...so I may have set something wrong as
I was bored and tired. That's why I need to deal with it by myself.
Thanks again,
bye
Gfr
.

Relevant Pages

  • Re: Server 2003 IPSec VPN
    ... I take it you used a ipsec tunneling policy and did not use Remote Access ... key lifetimes on the Windows 2003 Server it would not reset that often and I ... I do not have any rekey parameter settings configured on the ...
    (microsoft.public.windows.server.security)
  • Re: ipsec ISA to Watchguard
    ... While I'm not doing a IPSec to a ISA server, ... IP Address of other device/fw (Public) ... Remote (IP Subnet of LAN side) ... SA Settings ...
    (comp.security.firewalls)
  • Re: ipsec ISA to Watchguard
    ... While I'm not doing a IPSec to a ISA server, ... Remote Gateway: IP Address of other device/fw ... Remote (IP Subnet of LAN side) ... SA Settings ...
    (comp.security.firewalls)
  • RE: Using IPSEC to block IP
    ... Using IPSEC to block IP ... > anything with either IIS or WebBoard. ... I use the IPSec settings to assign complete packet filter settings to a hurd ... You DO need an Active Direcotry in place, otherwise centralized policies ...
    (Focus-Microsoft)