Re: PIX Configuration Help !

Post your question here:

Regards Colin.

"wonder" <adeel78@xxxxxxxxx> wrote in message
Hi Group,

I need to setup X-Auth and Radius (authentication only) on the PIX for
couple of users who will be connecting remotely through VPN Clients
with Pix.

LAN (Radius other servers)------PIX-----ADSL
Router---------Internet---------VPN Clients

Radius will be configured on Windows 2003 server and IIS service will
be enabled as well. Below is also pasted the current configuration.

PIX Version 6.3(1)
interface ethernet0 10baset
interface ethernet1 auto
nameif ethernet0 outside security0
nameif ethernet1 inside security100
enable password Xj encrypted
passwd DI encrypted
hostname Pix
fixup protocol ftp 21
fixup protocol h323 h225 1720
fixup protocol h323 ras 1718-1719
fixup protocol http 80
fixup protocol ils 389
fixup protocol rsh 514
fixup protocol rtsp 554
fixup protocol sip 5060
fixup protocol sip udp 5060
fixup protocol skinny 2000
fixup protocol smtp 25
fixup protocol sqlnet 1521
access-list out-in permit ip host any
access-list out-in permit icmp any any echo-reply
access-list out-in permit tcp any host x.x.x.27 eq smtp
access-list dialin permit ip host
pager lines 24
mtu outside 1500
mtu inside 1500
ip address outside x.x.x.26 255.255.255.X
ip address inside
ip audit info action alarm
ip audit attack action alarm
pdm history enable
arp timeout 14400
global (outside) 1 x.x.x.28
nat (inside) 0 access-list dialin
nat (inside) 1 0 0
static (inside,outside) x.x.x.27 netmask 0
access-group out-in in interface outside
route outside x.x.x.25 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225
timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00
timeout uauth 0:05:00 absolute
aaa-server TACACS+ protocol tacacs+
aaa-server RADIUS protocol radius
aaa-server LOCAL protocol local
url-server (inside) vendor websense host timeout 10
protocol TCP version 4
filter url http
no snmp-server location
no snmp-server contact
snmp-server community royalh
no snmp-server enable traps
floodguard enable
telnet inside
telnet timeout 5
ssh timeout 5
console timeout 0
url-block url-mempool 1500
url-block url-size 4
terminal width 80

I have looked at above mentioned 2 configurations but not sure if i am
right track or not. Any advice will be highly appreciated to get
started with this work.

Thanks in advance.