Using WebUI through Cisco VPN connection

From: kelly.j.martin@xxxxxxxxx
Date: 24 Apr 2006 08:46:49 -0700

I am trying to remotely manage my firewalls while remotely connected
via vpn connection to a Cisco VPN concentrator. I am able to connect
to the managable interface, get the log-in page and authenticate.
However, once I authenticate I am never able to display the webui page.
It eventually sits there and then gives me a "page cannot be
displayed" message. It is set up to manage via HTTP (shipping to
HTTPS) and when I am on the VPN concentrator I have an IP that is on
the same network/subnet as the firewall. I don't even pass through the
firewall to access the concentrator. Any ideas why this works
everywhere but through the VPN concentrator?

.

Prev by Date: Linksys BEFSX41 router/firewall Firmware Upgrade (1/11/2006)
Next by Date: Re: Linksys BEFSX41 router/firewall Firmware Upgrade (1/11/2006)
Previous by thread: Linksys BEFSX41 router/firewall Firmware Upgrade (1/11/2006)
Next by thread: Watchguard firebox x1000 hangs frequently
Index(es):
- Date
- Thread

Relevant Pages

Re: Cisco Secure ACS vs. Firewall
... Good points about the Cisco 3000 VPN Concentrator. ... mentioning about the *firewall* is that the VPN3K does basic NAT/Port ... RE>>on the company LAN is. ...
(Security-Basics)
RE: VPN concentrator placement
... We used a port on our Pix 515 to plug the public port of the ... The VPN Concentrator Is not a firewall and has lots of Holes out of the box ... I am doing a new install of a Cisco VPN concentrator on our existing network ...
(Security-Basics)
Re: PIX & VPN Concentrator LAN-to-LAN Tunnel Disconnected
... You may wish to investigate Troubleshooting on the VPN Concentrator: ... Found on Configuring the Cisco VPN 3000 Concentrator to the PIX ... Firewall: ... Brad Reese ...
(comp.dcom.sys.cisco)