Step by Step example needed for Netscreen - Netgear VPN access with NAT
From: Miles Davenport (milesd_at_)
Date: 04/28/04
- Next message: nalokeiki: "iPass"
- Previous message: Wolfgang Adamec: "firewall blocks retransmitted packet?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Date: Wed, 28 Apr 2004 21:56:18 +0100
I have been thrown in at the deepend, and asked to sort out a Netscreen -
Netgear VPN which is not working. I need someone to please give me a simple
example which I can work from.
The setup is as follows:
A netscreen needs to talk to a netgear. I am quite sure that there is NAT
being used as well. The VPN is needed so that a single PC at the
destination end can be accessed using VNC.
I have a fair understanding of the netgear menu logs etc, but am getting
confused by the following:
- in the VPN settings when a remote start IP address is mentioned, should
this be the private IP address (such as 192.168.3.1), or should it be the
address of the destination firewall/router ?
If the source and the destination are using NAT, does this change the config
at all ?
Can anyone recommend any tutorials, or books at all. I am probably getting
confused over simple stuff, and cannot see the wood for the trees.
Many thanks
Miles.
- Next message: nalokeiki: "iPass"
- Previous message: Wolfgang Adamec: "firewall blocks retransmitted packet?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
