Re: ZoneAlarm Problem on Startup
From: F-Y-I (no email)
Date: 01/06/03
- Next message: Claus Erichsen: "Re: ZAPro makes http-connection to VeriSign...?"
- Previous message: Dennis: "Norton Inernet Security/Netmeeting"
- In reply to: Budd O: "ZoneAlarm Problem on Startup"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
From: F-Y-I <> Date: Mon, 06 Jan 2003 04:12:03 -0600
I had the same problem as you describe. I finally unloaded the "said"
check to load at start up and manually loaded ZA after everything else
was loaded. I never could figure out the problem with the load
sequence.
About a year later, I reinstalled everything on my computer (clean
install) and ZA was back to it's happy self at startup. Btw, my
computer is an older Pentium and I wondered if the lack of Ram (64
meg) and the processer were not up to the load task sequence.
On Mon, 06 Jan 2003 02:35:35 GMT, "Budd O" <BuddO@cfl.rr.com> wrote:
>This has happened four times in the last two months. For some reason ZA
>stops loading when the system boots and return this error message, "The
>drive or network connection that the shortcut 'ZoneAlarm.Ink' refers to is
>unavailable. Make sure the disk is properly inserted or the network
>resource is available, and then try again". Has anyone had this problem?
>Usually I just do a full system restore from the last good back-up, but this
>is getting old. I am running version 3.1.395. What is causing this
>problem and how do I stop it from happening again?
- Next message: Claus Erichsen: "Re: ZAPro makes http-connection to VeriSign...?"
- Previous message: Dennis: "Norton Inernet Security/Netmeeting"
- In reply to: Budd O: "ZoneAlarm Problem on Startup"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
|
