Re: Zone Alarm - A Very Simple Question

From:
Date: 10/14/02 

Date: Mon, 14 Oct 2002 19:21:35 GMT

Only work round that seems to work is Control Panel, Internet Options,
Connections, place tick in Never dial a connection.
Will probably find though when IE etc opens that the dial out box
(assuming you've got it enable to appear) doesn't appear. Just make a
shortcut to it and select dial. Bit of a pain all round

regards
Graham

On Sun, 13 Oct 2002 15:13:06 GMT, "David" <davidwnh@adelphia.net>
wrote:

>Out of curiosity Pete look in your mail clients sent mail folder and see if
>there is any sent mail after this happens. It could be a virus, it could be
>ZA mailing home registration info, or it could be a bug. In any case if it
>is sending mail due to one of these reasons it may or may not be smart
>enough to delete any "sent mail" or other traces. Hopefully it is leaving
>traces.
>
>"Peter Hemmings" <peter@phemings.demon.co.uk> wrote in message
>news:WKOxS+AAQLq9Ewu0@phemings.demon.co.uk...
>> Like another thread, I just upgraded Zone Alarm (2.5 to 3.5) I knew I
>> should have left well alone! It all seems to work OK but it insists on
>> starting my mail client (Turnpike/Demon) every time it is loaded. Is
>> this normal? If so how can I stop it, if not what could be the cause of
>> the problem?
>> BTW I cannot load the old version as I do not have the setup file (I do
>> have a Ghost copy of the old drive but I am not an expert and do not
>> know what goes where!!
>> Thanks
>> --
>> Peter Hemmings

remove 2 from e-mail address to reply

Relevant Pages

  • Re: more scope questions
    ... 2 connections for horz plates. ... find the wire from the HV section to the anode ... for a picture of the tube socket. ... solder and broken traces... ...
    (alt.guitar.amps)
  • Re: ZoneAlarm -- a little problem after the latest update
    ... > Only work round that seems to work is Control Panel, Internet Options, ... > Connections, place tick in Never dial a connection. ...
    (comp.security.firewalls)
  • Re: XF551 SIO port problems
    ... Thanks, I have gone over every wire again, reheating the connections, ... and it works like a champ now! ... The traces do look pretty bad though, ...
    (comp.sys.atari.8bit)
  • Re: I killed my Hitachi 28" widescreen ;-(
    ... You may have bridged some traces or ... connections, or didn't properly solder some of them. ... If you are not experienced at TV servicing, your best bet would have to ...
    (sci.electronics.repair)