Re: identd log entries

From: /dev/rob0 (rob0_at_gmx.co.uk)
Date: 03/30/04 

Date: Tue, 30 Mar 2004 14:13:47 -0600

On Tue, 30 Mar 2004 20:58:39 +0100, Tim Haynes wrote:
> Yes, you must disconnect the box NOW and perform a full audit. Do not plug
> it back in until you're sure it's clean. In fact, it's time you got Mark to
> reinstall the box for you...

:)

Come on Tim, give it a shot. The answer's pretty easy.

Oh, and thanks for spoiling the punchline. Silly people who use word
wrap in Usenet, I swear ... ;) 

-- 
  /dev/rob0 - preferred_email=i$((28*28+28))@softhome.net
  or put "not-spam" or "/dev/rob0" in Subject header to reply

Relevant Pages

  • Re: Proper Radiator Cap Pressure Rating for 1994 Honda Accord EX?
    ... for the head, if you're lucky, no. head gaskets get big chunks eaten ... could be coolant, could be crossed thread, could be leaking plug gasket causing leaking gas to crud up the thread. ... when you have the head off, take the opportunity to run a tap through the threads to clean them. ...
    (rec.autos.makers.honda)
  • Re: 97 Ford Crown Vic-Wont idle when dead cold
    ... I know that when our Jeeps act like that a good clean of the TPS and IAC ... The plug and socket for them can be cleaned with a spray ... contact cleaner that any electronics shop sells. ... > My '97 crown vic is having difficulty holding an idle when started cold. ...
    (rec.autos.tech)
  • Re: Where to buy a welder cord
    ... I need a "service disconnect" which the plug and receptical do nicely. ... Heavier gauge wire is needed only for long runs, ...
    (rec.crafts.metalworking)
  • Re: No Boot, No POST and No Fans on ASUS P4B533-E!!!!
    ... first try turning the PS off and disconnect the plug. ... then after a minute plug it back in and turn the PS back on and see if that works. ... if you can get you hands on a PS just disconnect the old one and connect the new one to the main board connection,cpu and video card power and see if it boots. ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: AC Evaporator Box in 1982 300 TDT - Removal
    ... Disconnect the heater hoses at the firewall outside. ... Disconnect the AC hoses inside at the bottom of the expansion valve. ... It may have a brass hex plug into which is soldered a 1 or 2 mm wire ...
    (alt.auto.mercedes)