Remote Branch reconfiguration

Hello,

/First of all apologies if this is the wrong list./

I have, or rather had a few site to site vpn's set up. This is not my setup, but rather its

inherited . I have two remote branches terminating on one pix at the head office and another

vpn terminating on a different pix, also at the head office. On these tunnels I pass RDP

traffic aimed at a Term server. From the termserver, there is a seperate route out to the

internet for all hosts. The models of pix are 501's. I am led to believe that you can only

have a maximum of two tunnels terminating on any one 501 firewall. I presume this is why two

501's were used. Now to my issue: For reasons best left unsaid, the adsl line on the pix

with only one site to site vpn configured has had the line cancelled. This is causing me a

lot of grief from a customer and bearing in mind I dont know that much about cisco configs I

am at a bit of a loss of how to get the third and presently cancelled remote branch securely

connected to my head end. Would it be possible to configure an access list on the pix that

allows RDP traffic from the remote site - if so, then how? I have an Internet connection

available to me at the remote branch, I just need to know the best way to integrate into the

only available pix that is remaining.

To summarise:

Remote Branch A & VPN Head END PIX 1
Remote Branch B

Remote Branch C VPN Head END PIX 2 (Now Cancelled)

Possible:
Remote Branch C RDP (3389) Head END PIX 1


All the Pix's are 501's. Trm Server is Windows 2000. Clients are XP.

I hope this makes sense - any help much appreciated.

Regards

J

Relevant Pages

  • RE: Remote Branch reconfiguration
    ... Very true, I apologize. ... Note The PIX 501, PIX 506/506E, and PIX 520 security appliances are not ... Subject: Remote Branch reconfiguration ... vpn terminating on a different pix, also at the head office. ...
    (Security-Basics)
  • RE: Remote Branch reconfiguration
    ... Maximum Physical Interfaces: 6 ... What I would do is simply pull the configs from the old PIX 501 ... I have two remote branches terminating on one pix at the head ... available to me at the remote branch, I just need to know the best way to ...
    (Security-Basics)
  • RE: Remote Branch reconfiguration
    ... What I would do is simply pull the configs from the old PIX 501 ... I have two remote branches terminating on one pix at the head ... available to me at the remote branch, I just need to know the best way to ...
    (Security-Basics)
  • Re: VPN tp VPN via PIX
    ... interface of Hub PIX. ... As the PIX being firewall doesn't redirect traffic on the same ... terminating on different interfaces on the PIX this would also work. ...
    (comp.dcom.sys.cisco)
  • Re: IAS and browsing betwork
    ... Not sure what you mean by terminating at the other end.. ... but yes the pix is ... "Eugene Taylor" wrote: ...
    (microsoft.public.windows.server.general)