RE: modifying configuration registrar inside cisco 2600 so as to change password

From: Robert MacDonald (Robert.MacDonald_at_Haworth.com)
Date: 05/27/04

  • Next message: Damon Brinkley: "RE: Cisco CSA" 
    Date: Thu, 27 May 2004 07:19:13 -0400
To: <security-basics@securityfocus.com>

    http://www.cisco.com/warp/public/474/
     

    -----Original Message-----
    From: Kim Seng (Singnet) [mailto:query@singnet.com.sg]
    Sent: Wed 5/26/2004 10:12 AM
    To: security-basics@securityfocus.com



    Dear list,

    I have a used cisco 2600 router @ hand. Like to check how can I change with
    the password so as to access it. When I do a show version, the configuration
    settings is as below:
    0x2102

    Is there anywhere to recover it? I checked the internet, it seems that with
    the above configuration settings, I'm unable to issue break to go into ROM
    monitor. Is there any advise?

    Do take note that this router belobgs to me. But I got it from others who
    have forgotten the password. :p

    Thank you and best regards,

    Kim Seng

  • Next message: Damon Brinkley: "RE: Cisco CSA"

    Relevant Pages

    • C00D10B5
      ... help articles, for the router. ... I'm sure it's my configuration settings but can't seem ...
      (microsoft.public.windowsmedia.player)
    • Toshiba cant see wireless router
      ... >I have a Toshiba A45S250 Satellite Laptop with Atheros chipset ... >able to connect with a neighbor's D-link 802.11b router, ... >I've tried more permutations of configuration settings ... >for the specific SSID, but again no luck. ...
      (microsoft.public.windowsxp.general)
    • SDM no longer works
      ... could help me get the SDM interface working again. ... I set up the router and everything worked fine. ... the initial configuration settings before turning off the router. ...
      (comp.dcom.sys.cisco)
    • Re: Newbie-Router Unknown IP address
      ... You may not want to put that back on the network as it's IP ... address may conflict with the new router that was brought in. ... At that point you should be able to see the configuration settings of ...
      (comp.dcom.sys.cisco)
    • T1 Site-to-Site VPN
      ... Cisco 1841 ... crypto isakmp policy 1 ... set security-association level per-host ... Cisco Router and Security Device Manager is installed on this device. ...
      (comp.dcom.sys.cisco)