Re: Server Monitoring

From: Paul Devisser (paul@goopie.com)
Date: 05/01/02 

From: "Paul Devisser" <paul@goopie.com>
To: "Robert Bailey" <design7@optinemailing.net>, <security-basics@securityfocus.com>
Date: Wed, 1 May 2002 14:50:37 -0400

I use Big Brother (http://www.bb4.com/). I haven't had any problems except
the occassional false alarm... But with a bit of fine-tuning you can easily
get around that issue.

Paul Devisser

----- Original Message -----
From: "Robert Bailey" <design7@optinemailing.net>
To: <security-basics@securityfocus.com>
Sent: Tuesday, April 30, 2002 1:59 PM
Subject: Server Monitoring

> Looking for software that will monitor our servers and let us know when
> they go down. Anyone have any suggestions as to what they would suggest?
> Thanks!
>
> Robert
>
>
>
> 

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.351 / Virus Database: 197 - Release Date: 4/19/2002

Relevant Pages

  • Re: Powering off networx alarm security command panel?
    ... My brother figured it out. ... him to setup a code for the alarm. ... power still did not disabled. ... Remove one of the wires from under the ...
    (alt.security.alarms)
  • Re: Heat Sensors?
    ... thingie in the ceiling which I was told is a heat sensor. ... Does it trigger an alarm? ... put in smoke detectors, ... my brother bought a house with an alarm and he never used it. ...
    (alt.home.repair)
  • Helping a brother out
    ... My brother called me and asked me about hooking up power to a used cnc. ... Spindle drive unit alarm. ... So, I decided to look at spindle drive unit, checked cabling, remembered there are a lot ... Finally try extending tail stock and get chuck open alarm. ...
    (alt.machines.cnc)
  • Re: Helping a brother out
    ... Just to add a bit of torque to this, my brother in law works at the firm. ... So, I decided to look at spindle drive unit, checked cabling, remembered ... Finally try extending tail stock and get chuck open alarm. ...
    (alt.machines.cnc)