HoneyD-Win32 Parse Error --- ROADBLOCK
wrenm_at_prosum.com
Date: 06/23/05
- Previous message: Dan Tesch: "RE: nessus to PCI"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Date: 22 Jun 2005 22:12:33 -0000 To: pen-test@securityfocus.com('binary' encoding is not supported, stored as-is) Hi Roger –
First of all thank you for writing your book. After weeks of research I finally ran across it and it put all of the pieces together for me. Well, almost all of the pieces.
I have installed HoneyD-Win32 as described in your book and if I simply run the command “honeyd –d” it pops up and says it is listening. I can even see it catch traffic! Woo hoo!
The problem is when I try to feed it a config file. Even the most simplest of configurations give me a PARSE error. For example:
Create Windows 98
Annotate “Windows 98”
Set Windows 98 Personality “Windows 98”
BIND 1.1.1.1 Windows 98
I even double checked to make sure that “Windows 98” was defined in my nmap.prints file.
Any idea where I can go from here? I feel like I’m steps away from the holy grail but the final inches are stretching into miles.
Regards,
Wren
Sr. Consultant
Prosum Technology Group
- Previous message: Dan Tesch: "RE: nessus to PCI"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
|