Re: ip filters and blackice
From: Andrew Plato (aplato@anitian.com)Date: 11/29/01
- Previous message: Andrew Plato: "Re: IDS recommendations"
- Maybe in reply to: javier wilson: "ip filters and blackice"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Date: 29 Nov 2001 18:00:14 -0000 Message-ID: <20011129180014.12888.qmail@mail.securityfocus.com> From: Andrew Plato <aplato@anitian.com> To: focus-ids@securityfocus.com Subject: Re: ip filters and blackice('binary' encoding is not supported, stored as-is)
In-Reply-To: <00d301c17834$a7102450$82bd09c8@guegue.com.ni>
>I use w2k remote access policies to set ip filters for
>my RAS clients. Since I installed the new version of
BlackIce
>defender (2.9cai) my ip filters no longer work. They
would
>only work if I stop the blackice service and will not
work
>once I start the service again.
>
>I need both BlackIce for intrusion detection and ip
filters
>to restrict ras clients according to the options that
the
>remote access policies has.
>
>Any of you has had a similar problem, or know if this
is
>a known problem/issue of blackice?
Just to be sure I understand what you are doing...you
have filters on your RAS server that blocks RAS
clients from accessing certain IP addresses inside
your network? When you turn on BlackICE, those
clients can access those IP addresses? Whereas
when BI is off, they cannot?
IS that what is going on?
My first thought is that its an adapter problem with BI.
You could switch to the ICEADAPTER which might
help.
Andrew Plato
President / Principal Consultant
Anitian Corporation
www.anitian.com
- Previous message: Andrew Plato: "Re: IDS recommendations"
- Maybe in reply to: javier wilson: "ip filters and blackice"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]
Relevant Pages
|
