Re: [Full-disclosure] Gutmann's research paper today



On Tue, 2006-02-07 at 10:07 -0500, Valdis.Kletnieks@xxxxxx wrote:
One place where "random scrubbing" falls down is the requirement to *verify*
that the blocks were written. If you wrote a disk full of zeros, it's a
trivial matter to read it back and verify that all the bytes are zeros. If you
wrote a whole disk of pseudo-random, then you have to regenerate the entire
pseudo-random data stream in order to compare it....

Shouldn't you be able to do that cluster by cluster? Grab 1024 or
random, write it, then read it and verify?

Alternatively, more stream based, you could dd /dev/random, tee that to
the drive and pipe the other stream into md5. Take note of the hash. At
the end, dd the drive into md5 and compare the resulting hash.

I'm performing backups where the stream is tee'ed to the drive and into
md5 for hash creation. Works great with tapes, should work for drives
too.

Cheers,
Frank

--
It is said that the Internet is a public utility. As such, it is best
compared to a sewer. A big, fat pipe with a bunch of crap sloshing
against your ports.

Attachment: signature.asc
Description: This is a digitally signed message part

_______________________________________________
Full-Disclosure - We believe in it.
Charter: http://lists.grok.org.uk/full-disclosure-charter.html
Hosted and sponsored by Secunia - http://secunia.com/

Relevant Pages

  • Re: [kde-linux] k3b wont verify data
    ... I tell it to verify data after burning, it completes the burn, pops ... This bug has been there quite a while. ... It's not a simple k3b bug - verify works fine on many/most drives. ...
    (KDE)
  • Re: [kde-linux] k3b wont verify data
    ... I tell it to verify data after burning, it completes the burn, pops ... open the CD tray, waits patiently until I push the tray back in. ... This bug has been there quite a while. ... It's not a simple k3b bug - verify works fine on many/most drives. ...
    (KDE)
  • Re: [kde-linux] k3b wont verify data
    ... I tell it to verify data after burning, it completes the burn, pops ... open the CD tray, waits patiently until I push the tray back in. ... I have only a CD burner, although the drive is one of those combo drives ... Tough to nail down a date or a change since I do not burn that many CD's. ...
    (KDE)
  • SUMMARY: Veritas Netbackup on Solaris 8
    ... to verify hardware configuration of Robotic drives and correct the same. ... Robot and DLT drives. ... storage unit exists - I did verified and it does shows the correct ...
    (SunManagers)
  • Veritas Netbackup on Solaris 8
    ... StorEDGE L1000 tape Library with two DLT tape drives and it did detected ... Robot and DLT drives. ... storage unit exists - I did verified and it does shows the correct ... Verify that Media Manager Device daemon is running - ...
    (SunManagers)