Re: [fw-wiz] pix config for nat port 80 and port 8080 to same internal ip and port?
- From: "Paul Melson" <pmelson@xxxxxxxxx>
- Date: Thu, 20 Mar 2008 15:23:39 -0400
On Wed, Mar 19, 2008 at 8:03 PM, Jim Morris <ml@xxxxxxxxx> wrote:
Yes you get an error message, something like...
ERROR: duplicate of existing static
I think this error may be because one of your existing static rules matches.
Once you're in 'config term' mode issue matching "no static" commands to
remove the existing static NAT rules. Then run "clear xlate" and enter the
new static rule lines into the config.
PaulM
_______________________________________________
firewall-wizards mailing list
firewall-wizards@xxxxxxxxxxxxxxxxxxxxx
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards
- Follow-Ups:
- References:
- Prev by Date: Re: [fw-wiz] pix config for nat port 80 and port 8080 to same internal ip and port?
- Next by Date: Re: [fw-wiz] pix config for nat port 80 and port 8080 to same internal ip and port?
- Previous by thread: Re: [fw-wiz] pix config for nat port 80 and port 8080 to same internal ip and port?
- Next by thread: Re: [fw-wiz] pix config for nat port 80 and port 8080 to same internal ip and port?
- Index(es):
