Re: [fw-wiz] ipsec communications with windows server

What's the config on the router? Do you have xauth and config-mode disabled?

On 2/10/08, shadow floating <nadengine@xxxxxxxxxxxxxx> wrote:
Hi list,
i've been trying to get an IPSec communication channel to work between
a cisco 2811 router IOS 12.4 and a windows server that have ipsec
capabilities, have anyone tried this before and worked?
i want to have a secure communication between the windows management
host and the router via ipsec vpn
the ike phase one seems to be ok as but the quick mode always fails
though the same parameters are configured on both sides for a
trasparent mode vpn
any hints?

thanks alot
regards

Nad
_______________________________________________
firewall-wizards mailing list
firewall-wizards@xxxxxxxxxxxxxxxxxxxxx
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards

_______________________________________________
firewall-wizards mailing list
firewall-wizards@xxxxxxxxxxxxxxxxxxxxx
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards

Relevant Pages

  • Re: IPsec with WinXP(home ed.)
    ... "Wolfgang Keller" writes: ... the main issue I have had was the config on the windows ... >> Has anybody connected FreeBSD with WinXPvia IPsec? ... Do you by chance have a NAT router between the two? ...
    (comp.unix.bsd.freebsd.misc)
  • Re: Probleme with nm-16am v1.0
    ... the router worked perfectly until electrical outage then the tow cards ... sh start - displays the time the config was last saved *however* ... modem country microcom_hdms europe ... interface FastEthernet0/0 ...
    (comp.dcom.sys.cisco)
  • IPCOP|SMOOTHWALL+IPSEC+WINDOWS+ROUTER x VPN (lungo)
    ... I have problems with a VPN configurations I'm not able to set good; ... think that a physical router is interfereting with the VPN, ... IPCOP machine is visible directly from internet: I have config DLINK ... conn roarwarriors ...
    (comp.security.firewalls)
  • RE: deny access
    ... If this is an edge router you'd like secure it a bit more, ... Subject: deny access ... ACL to block one host would effectively block all hosts. ... From interface config mode, ...
    (Security-Basics)
  • Re: how to inquire about Linksys WAP54G wired to desktop?
    ... So it appears that changing from 15 on my router ... a setup screen for my AP I like your suggestion but I have no clue ... I didn't know my PC had an IP config ... I'm doing is done thru a wired connection -- I haven't yet used anything ...
    (alt.internet.wireless)