Re: [fw-wiz] Concentrator inside of paired failover firewalls.



On Fri, 2006-09-15 at 09:57 -0500, Nate Carlson wrote:
On Wed, 13 Sep 2006, Aaron Smith wrote:
Using a crossover cable is not a good idea.

http://marc.theaimsgroup.com/?l=firewall-wizards&m=110633896023171&w=2

Isn't this why you always want to set up multiple heartbeat channels?


How is that different/better than connecting the primary's interfaces to
one switch and the secondary's to a different switch?

@@ron
_______________________________________________
firewall-wizards mailing list
firewall-wizards@xxxxxxxxxxxxxxxxxxxxx
https://listserv.icsalabs.com/mailman/listinfo/firewall-wizards



Relevant Pages

  • Re: speakin a Hamers
    ... The key to good out-of-phase tones is connecting the pickups in series. ... neck + middle, and bridge + neck. ... one phase switch for each of two ... Connecting in series -if- bypassing a selector switch. ...
    (alt.guitar)
  • Re: Electrical Questions
    ... It's fairly a common way to power a switch. ... travelers to a load you would have connected them to each other and the ... How can one connect something to each traveler without connecting to ... So Switch-1 controls whether one side of the lamp is hot ...
    (alt.home.repair)
  • Re: LAN + shared Internet connection
    ... Gigabit Ethernet Switch? ... and simply run a cable from a LAN port on the router to a LAN port on the ... I am aware that it is possible to set up his office computer to use ... some problems getting the computers on the LAN connecting to each other. ...
    (microsoft.public.win2000.networking)
  • Re: Electrical Questions
    ... It's fairly a common way to power a switch. ... travelers to a load you would have connected them to each other and the ... How can one connect something to each traveler without connecting to ... So Switch-1 controls whether one side of the lamp is hot ...
    (alt.home.repair)
  • Re: Anyone successfully bonding 2 ether ports?
    ... I am a bit rusty on this, but if you setup the box with 2 ports configured with one IP address your connected layer 2 switch also needs some intelligence to know that you are running it this way. ... From memory Cisco's CDP use to get into trouble and had to be disbled if you setup a "loop" between two of their devices (eg connecting two L2 switches with two cables) in this way. ...
    (alt.os.linux.suse)