[fw-wiz] Check Point ISP Redundancy for Incoming Mail Service

From: Nick Brandson (nickbrandson_at_yahoo.com)
Date: 05/13/05

  • Next message: Ben Nagy: "RE: [fw-wiz] Extreme Problem with PIX Config" 
    To: firewall-wizards <firewall-wizards@honor.icsalabs.com>
Date: Fri, 13 May 2005 11:39:19 -0700 (PDT)

    Dear guru,

    Have had the ISP redundancy - load sharing mode turned
    on on my SecurePlatform cluster and worked perfectly
    fine.
    However, try to follow the R55 manual to set up for
    incoming mail server by using the GUIdbedit, I can
    switch the misp_dns_active to true and enter the
    misp_host_name successfully. But could NOT enter the
    IP addresses for from both ISP (interface), always
    showing "address 0 could not be added".

    Wanted to use the dbedit to modify the "script", what
    is the name of the script that mentioned in the
    manual? where is it located?

    Anyone has tried to configure for incoming traffic
    successfully?

    Do you think is it feasible to use ISP Redundancy for
    my mail server?

    Any ideas will be appreciated.

    Thanks again,
    Nick

                    
    Discover Yahoo!
    Have fun online with music videos, cool games, IM and more. Check it out!
    http://discover.yahoo.com/online.html
    _______________________________________________
    firewall-wizards mailing list
    firewall-wizards@honor.icsalabs.com
    http://honor.icsalabs.com/mailman/listinfo/firewall-wizards

  • Next message: Ben Nagy: "RE: [fw-wiz] Extreme Problem with PIX Config"